AT & HZ Nominal-Force Model Selector

AT & HZ Nominal-Force Model Selector

Enter a process-force target and selection margin to find the smallest listed model whose catalog force meets the resulting nominal-force threshold.

Set the selection boundary

Cylinder family

Required process force (kN)

Selection margin (%)

This screen compares listed nominal force only. It does not calculate installed workpiece force, drive size, circuit losses, or safety factors.

Choose the family boundary and enter a positive force target.

Release checks after the shortlist

Begin with calculated process load and the acceptance method.
Treat the margin as an engineering input, not a hidden default.
Keep each force value beside its source pressure.
Compare mounting dimensions against the available tool envelope.
Reconcile the HZ table with the selected HMPS operating point.
Confirm stroke and oil demand before assigning a drive unit.
Check return load, alignment, guiding, and side-force control.
Plan the hose route, fittings, protection, fill, and bleed points.
Review cycle rate, dwell, working hours, and heat limits.
Record available air pressure, flow, quality, and stability.
Attach part, tooling, frame, and station drawings when available.
Send unknown conditions as open questions in the RFQ.

Next step: send stroke, mounting, cycle, air conditions, line route, controls, and acceptance requirements for configuration review.

Request an engineering quote